Please refer to this sheet for an explaniation of how to read American Probe & Technologies probe model numbers.
Please refer to this sheet for an explaniation of how to read American Probe & Technologies probe model numbers.
The typical recommendation is to use a probe diameter that is half to two thirds the size of the contact. Remember, APT's probes are sold by the radius, so you must double the number to determine the diameter. It is normally found that a radius larger than 20 microns does not yield lower contact resistance. An example is: The contact pad is 10 microns, using the recommendation, you would then use a probe with a radius of 2.5 - 3.5 microns. (5- 7 micron diameter)
© 1986 - 2025 American Probe & Technologies. Edited 5/16/16 - Website Edited by CEllc
Hi! Could we please enable some additional services that require cookies? You can always change or withdraw your consent later.